STEP 2

Remove two LCD mask seals.
Remove two screws hidden under seals.

STEP 3

Put your fingers between the mask and the LCD screen and carefully release the mask latches.

STEP 4

Remove the mask. Do not hurry; twist the mask slightly to release latches.

STEP 5

Remove the mask screw seals on each side of the display assembly.
Remove screws.

STEP 6

Remove the securing tape from the display connector.
Disconnect the display cable.
Remove the screw securing the FL inverter.

STEP 7

Lift off the FL inverter board.
Disconnect FL inverter cables on both ends.

STEP 8

DONE!

If you would like to take apart the lapto case, check out this guide.